Cyclic corrosión chamber as standards ASTM B117-73; D17 11686; D172028; DIN 50014; DIN 50017-KK/ -KFW/ -KTW; DIN 50021-SS/ -ESS/ -CASS; DIN/IEC-68, parte 2-52; FORD EU B153-2; GENERAL MOTORS GM60-203; GENERAL MOTORS GM9540P/B; ISO 6270; ISO 9227; NES M-007; NISSAN M0007 CCTI, II, III y IV; RENAULT D17-1686; ROBERT GROUP RES 30CT107; SAE J1563; UNICNEM 692 y 741; VDA 621-415; VOLKSWAGEN P-1210.


Possibility to manufacture the climatic chamber with special measures.

Standard equipment

  • Our chambers are manufacture in AISI 304 stainless steel tubular structure. AISI 304 stainless steel exterior, painted and dryer in oven. AISI 316L stainless steel interior.
  • Double slope roof methacrylate lid, (incline 30º) that prevents saline solution dripping on the sample.
  • Watertight closing by hydrostatic gasket.
  • Specimen bars. Forming bars support inside Chamber.
  • Saline solution spray system made in methacrylate. Adjustable speed pump.
  • Automatic cleaning of the circuit at the end of the trial.
  • PID temperature controller with set point programmers. Configurable logic output for events.
  • RS232 serial port for connection to PC.
  • Management PLC: start/stop equipment; temperature control of water Stainless Steel cylinder humidifier ; programmable test time, with automatic stop after the test; total hour meter, (usable life of the Chamber) and partial (test time); spray manual cleaning; current state of the Chamber.
  • Separate thermostat for over temperature with shutdown of the heating system.
  • Low noise level.
  • Low power consumption.
  • CFC and HCFC free refrigerant, under international environmental regulations.

Optional equipment

  • Pneumatic opening in 1000 y 2000 liters models.
  • 200 liters reserve tank of saline solution: cover, metal frame with a direct connection to the Chamber. 100/140 hours autonomy.
  • Rain gauge with graduated scale.
  • Set of 4 PVC support bars.
  • Sample support in angle between 60º and 75º (DIN 50.021).
  • Chart recorder paper 100 mm where register up to four process variables (solid line) or six (multipoint). High visibility display with seven segments providing clear numerical indications of process variables and alarm status. Annotation of the date / time and posts chart.
  • Software for configuration and commissioning of the drivers from a PC. Allows data registration, creation and recovery of configuration files, clone computers, communications and supervision.